Acoustic analysis
Where it is
Section titled “Where it is”Not a setup-tree node. Embedded in the application.
Controls
Section titled “Controls”ANALYSIS
Section titled “ANALYSIS”Frequency
Section titled “Frequency”- Control: value (
ValueField) - Unit: Hz
- Value modes: none (plain entry)
Run a sweep of studies at different frequencies to find a resonance — a single solve answers one frequency, not a range.
VIBRATING PART
Section titled “VIBRATING PART”Driven by
Section titled “Driven by”- Control: choice (
ComboRow) - Options: ``
Wetted face
Section titled “Wetted face”- Control: choice (
ComboRow) - Shown when:
AcousticState.structuralSource !== ""
Max gap
Section titled “Max gap”- Control: value (
ValueField) - Unit: m
- Value modes: none (plain entry)
- Shown when:
AcousticState.structuralSource !== ""
Refuse the mapping if any acoustic face is further than this from the part’s surface. Two meshes of the same geometry keep it at a fraction of an element; 0 disables the check.
Problems reported against this step
Section titled “Problems reported against this step”The application reports no problems against this step.
… marks a value the application computes at run time, so the source carries no fixed text for it.