EM boundaries
Where it is
Section titled “Where it is”Not a setup-tree node. Embedded in the application.
Controls
Section titled “Controls”BOUNDARIES
Section titled “BOUNDARIES”＋ Potential
Section titled “＋ Potential”- Control: action (
ToolButton2) - Shown when:
!root.magnetic
- Control: action (
ToolButton2)
Conditional and repeated groups
Section titled “Conditional and repeated groups”Per item in EmState.boundaries
Section titled “Per item in EmState.boundaries”repeated once for every entry in EmState.boundaries
- Control: choice (
ComboRow)
Remove
Section titled “Remove”- Control: action (
ToolButton2)
- Control: choice (
ComboRow)
Potential
Section titled “Potential”- Control: value (
ValueField) - Unit: V
- Value modes: none (plain entry)
The in-app guidance depends on the case:
- Held there. Zero volts on the face that is grounded is the usual reference, and every other voltage is measured against it.
- Positive is current going into the part.
- Charge sitting on the surface, not a potential — the face finds its own voltage.
Problems reported against this step
Section titled “Problems reported against this step”The application reports no problems against this step.
… marks a value the application computes at run time, so the source carries no fixed text for it.