Solid refinements
Where it is
Section titled “Where it is”Not a setup-tree node. Embedded in the application.
Controls
Section titled “Controls”LOCAL ELEMENT SIZE
Section titled “LOCAL ELEMENT SIZE”Add a refinement
Section titled “Add a refinement”- Control: action (
ToolButton2)
Conditional and repeated groups
Section titled “Conditional and repeated groups”Per item in CaseState.solidRefinements
Section titled “Per item in CaseState.solidRefinements”repeated once for every entry in CaseState.solidRefinements
- Control: choice (
ComboRow)
Remove
Section titled “Remove”- Control: action (
ToolButton2)
- Control: value (
ValueField) - Unit: mm
- Value modes: none (plain entry)
Smaller than the general size, or it does nothing: this is a cap on that face, not an override of it. Around a fillet, three or four elements across the radius is the usual target — two cannot represent a curved stress field and will under-report the peak.
Problems reported against this step
Section titled “Problems reported against this step”The application reports no problems against this step.
… marks a value the application computes at run time, so the source carries no fixed text for it.