Solid layers
Where it is
Section titled “Where it is”Not a setup-tree node. Embedded in the application.
Controls
Section titled “Controls”INFLATION LAYERS
Section titled “INFLATION LAYERS”Add a layer stack
Section titled “Add a layer stack”- Control: action (
ToolButton2)
Conditional and repeated groups
Section titled “Conditional and repeated groups”Per item in CaseState.solidLayers
Section titled “Per item in CaseState.solidLayers”repeated once for every entry in CaseState.solidLayers
- Control: choice (
ComboRow)
Remove
Section titled “Remove”- Control: action (
ToolButton2)
First layer
Section titled “First layer”- Control: value (
ValueField) - Unit: mm
- Default:
0.0002 - Value modes: none (plain entry)
The thickness of the element against the face itself. This is the number that decides whether the layer resolves anything; the two below only decide how far it reaches before handing over to the bulk mesh.
Layers
Section titled “Layers”- Control: value (
ValueField) - Default:
5 - Value modes: none (plain entry)
How many. Enough that the last one is comparable to the surrounding element size — a stack that stops abruptly at a tenth of it leaves a jump the mesher has to absorb in one element.
Growth
Section titled “Growth”- Control: value (
ValueField) - Default:
1.2 - Value modes: none (plain entry)
The ratio between one layer and the next. Between 1.1 and 1.3 is the usual range; much above that and the jump from the last layer to the bulk is as abrupt as having no layers at all.
Problems reported against this step
Section titled “Problems reported against this step”The application reports no problems against this step.
… marks a value the application computes at run time, so the source carries no fixed text for it.